Fix USB Error Code 52 Windows cannot verify the digital signature: If you have recently installed Windows Updates or upgraded Windows then it’s possible that your USB ports will not recognize any hardware that is connected to them. In fact, if you will dig further you will find out the following error message in Device Manager:
Windows에서 이 장치에 필요한 드라이버의 디지털 서명을 확인할 수 없습니다. 최근 하드웨어 또는 소프트웨어 변경으로 인해 서명이 잘못되었거나 손상된 파일이 설치되었거나 출처를 알 수 없는 악성 소프트웨어가 설치되었을 수 있습니다. (코드 52)
Error Code 52 indicates a driver failure and in device manager, you will see a yellow exclamation mark next to each USB icon. Well, there is no particular cause for this error but a number of reasons are responsible such as Corrupted Drivers, Secure boot, Integrity check, problematic filters for USB etc. So without wasting any time let’s see how to actually Fix USB Error Code 52 Windows cannot verify the digital signature with the help of below-listed troubleshooting guide.
Fix USB Error Code 52 Windows cannot verify the digital signature
혹시라도 문제가 생길 경우를 대비해 복원 지점을 만들어 두시기 바랍니다.
Method 1: Delete USB UpperFilter and LowerFilter Registry Entries
참고 : Backup the registry just in case something goes wrong.
1. Windows 키 + R을 누른 다음 입력 regedit를 Enter 키를 눌러 레지스트리 편집기를 엽니다.
2.Navigate to the following the Registry Key:
HKEY_LOCAL_MACHINESYSTEMCurrentControlSetControlClass{36FC9E60-C465-11CF-8056-444553540000}
3. 꼭 선택하세요 {36FC9E60-C465-11CF-8056-444553540000} and then in the right window pane find UpperFilters 및 LowerFilters.
4.각각을 마우스 오른쪽 버튼으로 클릭하고 선택하십시오. 삭제합니다.
5. PC를 재부팅하여 변경 사항을 저장합니다.
방법 2: 시스템 복원 실행
1. Windows 키 + R을 누르고 "를 입력하세요."sysdm.cpl을” 그런 다음 Enter 키를 누릅니다.
2.Select 시스템 보호 탭하고 선택 시스템 복원.
3.다음을 클릭하고 원하는 것을 선택하세요. 시스템 복원 지점.
4. 화면의 지시에 따라 시스템 복원을 완료합니다. 그리고 당신이 할 수 있는지 확인하십시오 Fix USB Error Code 52 Windows cannot verify the digital signature, 그렇지 않은 경우 아래 나열된 방법을 계속 진행하십시오.
Method 3: Disable Secure Boot
1.Restart your PC and tap F2 or DEL depending upon your PC to open Boot Setup.
2.Find the Secure Boot setting, and if possible, set it to Enabled. This option is usually in either the Security tab, the Boot tab, or the Authentication tab.
#경고: 보안 부팅을 비활성화한 후에는 PC를 공장 상태로 복원하지 않고는 보안 부팅을 다시 활성화하기 어려울 수 있습니다.
3.Restart your PC and see if you’re able to Fix USB Error Code 52 Windows cannot verify the digital signature.
Method 4: Disable Driver Signature Enforcement
For Windows 10 user’s, interpret the Windows booting process 3 times to boot into recovery mode or else you could try the following:
1.Go to the Login screen where you see the above error message then click on 전원 버튼 그럼 보류 변화 그리고 클릭 다시 시작 (while holding the shift button).
2. 다음이 보일 때까지 Shift 버튼에서 손을 떼지 마십시오. 고급 복구 옵션 메뉴.
3.이제 고급 복구 옵션 메뉴에서 다음으로 이동합니다.
문제 해결 > 고급 옵션 > 시작 설정 > 다시 시작
4. 다시 시작을 클릭하면 PC가 다시 시작되고 옵션 목록이 포함된 블루 스크린이 표시됩니다. "라는 옵션 옆에 있는 숫자 키를 눌러야 합니다.드라이버 서명 시행을 비활성화합니다."
5.Now Windows will boot again and once logged into Windows press Windows Key + R then type devmgmt.msc를 Enter 키를 눌러 장치 관리자를 엽니다.
6.Right-click on the problematic device (which has a yellow exclamation mark next to it) and select 드라이버를 업데이 트합니다.
7.“를 선택하세요업데이트 된 드라이버 소프트웨어를 자동으로 검색합니다."
8.Repeat the above process for every problematic device listed in Device Manager.
9. PC를 재부팅하여 변경 사항을 저장하고 Fix USB Error Code 52 Windows cannot verify the digital signature.
Method 5: Uninstall Problematic devices
1. Windows 키 + R을 누른 다음 입력 devmgmt.msc를 Enter를 누르십시오.
2.오른쪽 클릭 each of problematic device (yellow exclamation mark next to it) and select 제거.
3.Click Yes/OK to continue with uninstallation.
4. PC를 재부팅하여 변경 사항을 저장합니다.
Method 6: Delete usb*.sys Files
1.Take Ownership of the files C:Windowssystem32driversusbehci.sys and C:Windowssystem32driversusbhub.sys through any one of the listed methods here.
2.Rename the usbehci.sys and usbhub.sys 에 파일 usbehciold.sys & usbhubold.sys.
3. Windows 키 + R을 누른 다음 입력 devmgmt.msc를 Enter를 누르십시오.
4.확장 범용 직렬 버스 컨트롤러 그런 다음 마우스 오른쪽 버튼을 클릭하십시오. Standard Enhanced PCI to USB Host Controller 선택 제거.
5.Reboot your PC and new drivers will be automatically installed.
Method 7: Run CHKDSK and SFC
1.Press Windows Key + X then click on Command Prompt(Admin).
2. 이제 cmd에 다음을 입력하고 Enter 키를 누릅니다.
sfc /scannow sfc /scannow /offbootdir=c: /offwindir=c:windows
3. 위의 프로세스가 완료될 때까지 기다렸다가 완료되면 PC를 다시 시작합니다.
4.다음으로 여기에서 CHKDSK를 실행하세요. 디스크 검사 유틸리티(CHKDSK)를 사용하여 파일 시스템 오류를 수정하세요.
5. 위의 프로세스를 완료하고 PC를 다시 재부팅하여 변경 사항을 저장합니다.
당신이 할 수 있는지 확인 Fix USB Error Code 52 Windows cannot verify the digital signature, if not then follow the next method.
Method 8: Disable Integrity Checks
1. Windows 키 + X를 누른 다음 선택 명령 프롬프트 (Admin).
2. cmd에 다음 명령을 입력하고 각 명령 다음에 Enter를 누르십시오.
bcdedit - 로드 옵션 설정 DDISABLE_INTEGRITY_CHECKS
bcdedit - TESTSIGNING ON 설정
3.If the above command doesn’t work then try the following:
bcdedit / 삭제 값로드 옵션
bcdedit - 테스트 서명 끄기 설정
4. PC를 재부팅하여 변경 사항을 저장합니다.
당신을 위해 추천 된:
그게 당신이 성공적으로 Fix USB Error Code 52 Windows cannot verify the digital signature 하지만 이 가이드에 관해 여전히 질문이 있는 경우 댓글 섹션에서 자유롭게 질문하세요.