Fix Windows Cannot Be Installed to Drive 0: If you are trying to install Windows 10 or Windows 8 on your PC chances are you may receive the error message “Windows cannot be installed to disk # partition #”. Also, if you continue further and click Next, you will again receive another error message “Windows was unable to install to the selected location” and the installation will exit. In short, you won’t be able to install Windows because of this error message.
Now the hard drive has two different partitioning system namely MBR (Master Boot Record) and GPT (GUID Partition Table ). In order to install your Windows on the hard disk, the correct partition system must be selected beforehand, for example, if your computer boots into Legacy BIOS then the MBR partition system should be used and if it boots into UEFI mode then the GPT partition system should be used. So without wasting any time let’s see how to actually Fix Windows Cannot Be Installed to Drive 0 error with help of below-listed troubleshooting guide.
SOLVED: Windows Cannot Be Installed to Drive 0
Method 1: Change the Boot option
1.Turn off your laptop, then turn it on and simultaneously pehia te F2, DEL, F12 ranei (i runga i to kaihanga) ki te uru ki roto tatūnga BIOS.
2.Under BIOS setup search for Boot options and then look for UEFI/BIOS Boot mode.
3.Now select either Legacy or UEFI depending on your hard drive. If you have a GPT partition tīpako UEFI and if you have MBR wehewehenga tīpako BIOS tuku iho.
4.Save changes and then exit BIOS.
Method 2: Convert GPT to MBR
Tuhipoka: This will erase all the data on your hard drive, backup your data before continuing with this step.
1.Boot from installation media and then pāwhiritia te Tāuta.
2.Now on the next screen press Shift + F10 ki te tuwhera Whakaaetia te Whakatairanga.
3. Patohia te whakahau e whai ake nei ki te cmd ka pa ki te Whakauru i muri i ia waahanga:
diskpart list disk select disk 0 (Note: Change the number 0 according to the disk you want to convert) convert mbr exit
4.Now the disk will be converted to MBR partition and you can continue with the installation.
Method 3: Completely Easre the partition
Tuhipoka: Make sure to backup all your data before continuing as this will completely erase all your data.
1.Boot from installation media and then click Tāuta.
2.Now on the next screen press Shift + F10 to open Command Prompt.
3.Type the following command and hit Enter after each one:
diskpart list disk select disk 0 (Note: Change the number 0 according to the disk you want to convert) clean exit
4.This will erase all the data and then you can continue with the installation.
E taunaki ana mo koe:
Koira kua angitu koe Fix Windows Cannot Be Installed to Drive 0 engari mena kei a koe etahi patai mo tenei aratohu, tena koa patai ki te waahanga korero.