Fix Error 1962: No Operating System Found: If you are facing this error then it may be because of corrupt boot sequence or the boot order priority might be not configured correctly. In any case, you when you try to boot your PC you won’t be able to boot your operating system instead you will be faced with the Error 1962 No Operating System Found message and you won’t have any option but to restart your PC which will again land you on the same error message screen.
Error 1962: No operating system found. Boot sequence will automatically repeat.
The strange thing with the error 1962 is that user might be able to successfully boot to Windows after waiting for few hours but that might not be the case with everyone. So you can check if you can access your system after waiting for few hours. Whereas some affected users can’t even get into BIOS setup as the Error 1962 No Operating System Found message is displayed immediately after the computer boots up.
Well, now you know enough about error 1962 let’s see how to actually fix this error. The good thing about this error it can also be caused simply because of faulty SATA cable which connects your Hard disk to the motherboard. So you need to perform various checks in order to determine the cause of Error 1962 No Operating System Found message on boot. Without wasting any time let’s see how to actually fix this issue with the below-listed troubleshooting methods.
錯誤 1962:未找到作業系統 [已解決]
Before trying any advanced steps we need to check whether it’s a case of faulty Hard disk or the SATA cable. In order to check if the hard disk is working or not, connect it to another computer and verify if you’re able to access it, if you’re able to then it’s not the case of the faulty Hard disk. But if you’re still not able to access the hard disk on another PC then you need to replace your Hard disk.
Now check if the SATA cable is at fault, just use another PC cable in order to check if the cable is faulty. If this is the case then simply buying another SATA cable might fix the issue for you. Now that you have verified if it’s not the case of faulty HDD or SATA cable then you can continue to the below-listed steps.
注意: In order to try below fixes you need to use Windows Installation or Recovery disc, so make sure you are ready with any one of them before hand.
方法1:運行自動/啟動修復
1.插入 Windows 10 可啟動安裝 DVD 並重新啟動您的 PC。
2.當提示按任意鍵從 CD 或 DVD 啟動時,按任意鍵繼續。
3.選擇您的語言首選項,然後單擊下一步。 單擊修復 你的電腦在左下角。
4.在選擇選項屏幕上,單擊 疑難解答.
5.在疑難解答屏幕上,單擊 高級選項.
6.在高級選項屏幕上,單擊 自動修復或啟動修復.
7.等到 Windows 自動/啟動修復 完成。
8.重啟就成功了 Fix Error 1962 No Operating System Found.
另外,請閱讀 如何修復“自動修復”無法修復您的電腦。
Method 2: Run Diagnostic Test
If the above method weren’t helpful at all then there is a chance that your hard disk might be damaged or corrupted. In any case, you need to replace your previous HDD or SSD with a new one and install Windows again. But before running to any conclusion, you must run a Diagnostic tool to check if you really need to replace HDD/SSD.
要運行診斷程序,請重新啟動您的 PC 並在計算機啟動時(在啟動屏幕之前),按 F12 鍵,當啟動菜單出現時,突出顯示啟動到實用程序分區選項或診斷程序選項,然後按 Enter 鍵啟動診斷程序。 這將自動檢查系統的所有硬件,並在發現任何問題時進行報告。
Method 3: Set correct boot order
You may be seeing the “Error 1962 No Operating System Found” because the boot order is not properly set which means that computer is trying to boot from another source which doesn’t have an operating system thus failing to do so. In order to fix this issue you need to set the Hard Disk as the top priority in the Boot order. Let’s see how to set proper boot order:
1.當您的計算機啟動時(在啟動屏幕或錯誤屏幕之前),反复按 Delete 或 F1 或 F2 鍵(取決於您的計算機製造商)以 進入BIOS設定.
2.進入 BIOS 設置後,從選項列表中選擇 Boot 選項卡。
3.現在確保計算機 Hard disk or SSD is set as a top priority in the Boot order. If not then use up or down arrow keys to set hard disk at the top which means the computer will first boot from it rather than any other source.
4.Once above changes are done move to the Startup tab and make the following changes:
主引導順序
CSM:[啟用]
Boot Mode: [Auto]
Boot Priority: [UEFI First]
Quick Boot: [Enable]
Boot up Num-lock Status: [On]
5.Press F10 to save and exit changes in the BIOS setup.
方法 4:啟用 UEFI 啟動
Most UEFI firmware (Unified Extensible Firmware / 硬體 Interface) either contains bugs or are misleading. This is because of the frequent evolution of the firmware which has made UEFI too complicated. The Error 1962 No Operating System Found seems to be caused by UEFI firmware and when you reset or set the default value of UEFI it seems to fix the issue.
You have to configure CSM (Compatibility Support Module) to enable if you want to boot to a legacy Operating System (OS). If you have recently upgraded your Windows installation then this setting is disabled by default which disables the support for the older Operating System’s which in turn won’t let you boot to OS. Now be careful to set the UEFI as the first or only boot method (which is already the default value).
1.Restart your PC and tap F2 or DEL depending upon your PC to open Boot Setup.
2.Go to the Startup tab and make the following changes:
將啟動清單選項變更為 UEFI 停用載入傳統選項 ROM 啟用安全啟動
3.接下來,點選 F10 儲存並退出引導設定。
Method 5: Restore your PC using Recovery Disc
1.Put in the Windows installation media or Recovery Drive/System Repair Disc and select your l語言偏好,然後按一下“下一步”
2.Click 修復 您的計算機位於底部。
3.Now choose 疑難解答 進而 高級選項。
4..Finally, click on ““系統還原”” and follow onscreen instructions to complete the restore.
5.Restart your PC and this step may have Fix Error 1962 No Operating System Found.
方法 6:修復安裝 Windows 10
如果上述解決方案都不適合您,那麼您可以確定您的硬碟沒有問題,但您可能會看到錯誤“Error 1962 No Operating System Found「因為作業系統或硬碟上的 BCD 資訊被某種方式刪除了。那麼,在這種情況下,您可以嘗試修復安裝 Windows,但如果這也失敗,那麼剩下的唯一解決方案就是安裝 Windows 的新副本(全新安裝)。
為你推薦:
這樣你就成功了 Fix Error 1962: No Operating System Found 但如果您對本指南仍有任何疑問,請隨時在評論部分提問。