Fix Windows Cannot Be Installed to Drive 0: If you are trying to install Windows 10 or Windows 8 on your PC chances are you may receive the error message “Windows cannot be installed to disk # partition #”. Also, if you continue further and click Next, you will again receive another error message “Windows was unable to install to the selected location” and the installation will exit. In short, you won’t be able to install Windows because of this error message.
Now the hard drive has two different partitioning system namely MBR (Master Boot Record) and GPT (GUID Partition Table ). In order to install your Windows on the hard disk, the correct partition system must be selected beforehand, for example, if your computer boots into Legacy BIOS then the MBR partition system should be used and if it boots into UEFI mode then the GPT partition system should be used. So without wasting any time let’s see how to actually Fix Windows Cannot Be Installed to Drive 0 error with help of below-listed troubleshooting guide.
SOLVED: Windows Cannot Be Installed to Drive 0
Method 1: Change the Boot option
1.關閉你的筆記本電腦,然後同時打開它 按 F2、DEL 或 F12 (取決於您的製造商)進入 BIOS 設置。
2.Under BIOS setup search for Boot options and then look for UEFI/BIOS Boot mode.
3.Now select either Legacy or UEFI depending on your hard drive. If you have a GPT 分區 選擇 UEFI 如果你有 MBR 分 選擇 舊版 BIOS。
4.Save changes and then exit BIOS.
Method 2: Convert GPT to MBR
注意: This will erase all the data on your hard drive, backup your data before continuing with this step.
1.Boot from installation media and then 單擊安裝。
2.Now on the next screen press SHIFT + F10 打開 命令提示符。
3. 在 cmd 中鍵入以下命令,並在每個命令後按 Enter 鍵:
diskpart list disk select disk 0 (Note: Change the number 0 according to the disk you want to convert) convert mbr exit
4.Now the disk will be converted to MBR partition and you can continue with the installation.
Method 3: Completely Easre the partition
注意: Make sure to backup all your data before continuing as this will completely erase all your data.
1.Boot from installation media and then click 安裝。
2.Now on the next screen press Shift + F10 to open Command Prompt.
3.Type the following command and hit Enter after each one:
diskpart list disk select disk 0 (Note: Change the number 0 according to the disk you want to convert) clean exit
4.This will erase all the data and then you can continue with the installation.
為你推薦:
這樣你就成功了 Fix Windows Cannot Be Installed to Drive 0 但如果您對本指南仍有任何疑問,請隨時在評論部分提問。